RF Switch Supports Wideband Operation With Low Insertion Loss

pSemi Corporation, a Murata company, has released the PE423213 RF switch operating from 300 MHz to 10.6 GHz. The HaRP-technology-enhanced reflective single-pole double-throw (SPDT) device is based on the company's UltraCMOS+ silicon-on-insulator technology for wireless applications.
The PE423213 SPDT switch can be used in ISM, WLAN, Wi-Fi, Bluetooth, and ultra-wideband (UWB) systems. These technologies are used in smart home devices, asset trackers, and secure access systems. The switch can steer high-frequency signals for UWB applications used for short-range positioning.
The RF switch connects a common RF port to one of two signal paths to allow devices to switch between antennas or RF circuits. Its wide frequency coverage supports multiple wireless standards using the same component, simplifying RF front-end design.
Offering a low insertion loss and high isolation, the RF switch exhibits a typical insertion loss of 0.4 dB at 6 GHz, increasing to 0.5 dB at 8.5 GHz, and 0.7 dB at 10.6 GHz. The corresponding isolation values are 28 dB, 25 dB, and 18 dB, respectively.
Low insertion loss preserves signal strength through the selected path, and high isolation reduces signal leakage into the inactive path. The specifications also show how RF performance changes across the operating range, with higher insertion loss and lower isolation at 10.6 GHz.
The typical supply current is 95 nA. The switch's low current consumption makes it a good candidate for battery-powered wireless equipment where power consumption is an important design consideration.
The switch also has a typical fast switching time of 100 ns for responsive RF path selection. A single digital control input selects the active path to reduce the number of control connections required from the host processor.
The device is housed in a six-lead, 1.6 × 1.6-mm DFN package with an operating temperature range from -40°C to 105°C. pSemi also specifies an electrostatic discharge rating of 2,000 V under the human body model.
An EK423213-01 evaluation kit is available to test the switch's RF performance. The product documentation includes downloadable S-parameter data and Gerber files to allow engineers to evaluate frequency dependent RF characteristics and reference printed-circuit-board layouts during development. pSemi showcased the PE423213 at electronica 2026, November 10-13.
The post RF Switch Supports Wideband Operation With Low Insertion Loss appeared first on Embedded.